null Skip to main content

Insert Measuing guide

Insert Measuring Guide

 

 

How To Measure Your Patio Door Or Sliding Window For Pet Door Insert

 

Measuring for the Patio Pet Door or Side Sliding Window Insert

To determine which height range will work with your slider, open the slider and measure from the very bottom inside track to the very top inside track. As you look down on the groove that the slider follows on the floor, you may see a thin rail. You will want to measure down past that rail, from the deepest part of the channel on the floor to the very top inside channel above. As you look at the track on the floor your slider follows; you most often will see a "rail". If this "rail" is narrower than 5/16" (as you look down on it), then the Security Boss Patio Pet Doors should fit your slider. 
 

Measuring for a Sash Window Insert

To determine the correct range of window insert you need, open your sash window and measure from left to right inside the channel that the sash window travels up and down in. You want to measure into the deepest part of the channel since the window insert will expand due to the spring loaded end. Your measurement should be with the adjustment range chosen. You might notice that your measurement falls into two ranges, select the once that will allow some room below and above your window width. This will allow the unit to compress enough to insert into your channel and still expand enough for a tight fit. You can always call us for personalized guidance to ensure your choice is correct.
 

What is the Rise?

This is the distance from the bottom of the patio insert to the bottom edge of the pet door frame. The Rise elevates the pet opening. For example a 2" rise will be the same as setting the pet door itself on a 2" block. There are several different rise options available (2", 4", 6", and 8" inches) to accommodate different pets. Selecting the rise along with the proper sized pet opening should result in the opening being higher than the shoulders of your pet to prevent the flap from pinching and also result in an easy step over height that they can use even as they age. As a rule of thumb, a pet opening should be 1.5 - 2" higher than your tallest pet's shoulders.

 

Included Weather stripping

Every Security Boss Insert features a replaceable bulb seal that lines both sides of the insert. This bulb seal provides a superior weather seal between the insert and the wall and slider This weather seal can also be replaced if needed very easily by sliding the weatherstripping into the t-slot groove on your slider.


The weather seal is a 3" wide vinyl weather stripping section that attaches to the back side of your slider. When an insert is installed, your slider breaks the seal between the slider and fixed panel. This weather stripping will seal out any drafts.


Adjustable Range

One side of your insert floats on two tension rods that compress or expand to obtain the best possible fit in the door or window frame. Once in place, there are two thumb bolts that lock the adjustable section into place to prevent the insert from being removed from the outside.
 
 
You can add 2 inch extensions to the adjustable side of all inserts to extend their reach or adjustment range. These extensions snap into your insert and fit tightly. No screws or hardware are required. It is possible to add more than two (2) extensions on the Security Boss Inserts. The snap in lock feature of the extensions allow for a stable firm unit regardless of the number of extensions are added.

There are no products listed under this category.