1-Combination Stud Finder and level
12 ft. Power Lock Tape Measure
1-Calibrated Speed Square
7-Piece Set of 12" drill bits (From 1/8" to 1/2" diameter)
4 Ft.- Backer Rod
2.7 Fl Oz. of Superflex Silicone Adhesive
1-Snap-Off Blade All Purpose Utility Knife

Use of Tools:

7-Piece Set of 12" Drill Bits - After marking your wall where the cut will be; use the 1/2" diameter 12" drill bit to drill a hole in each of the 4 corners of your cut out markings. By using a 12" bit, you can drill completely through the wall so that you will have guide holes on the exterior side of your wall. You can then simply connect the holes by using a jigsaw to form your rough cut. The extra bits we included for any future home projects you might encounter.
Note:Ensure that there is no electrical wiring or water piping in the area you are installing any pet door. If unsure, we suggest contacting a certified installer or contractor for assistance.

Utility Knife - The utility knife can be used to trim and rough edges or to score a cut through the sheet rock. Handy tool to have.

Backer Rod - For situations where you have gap between the exterior frame of the pet door and the door itself. The Backer Rod is soft and pliable, allowing your to tear of pieces to fill any gaps, which can then be sealed with the included Silicone caulking.

2.7 oz. Superflex Silicone Adhesive - Silicone is commonly used to seal around the exterior sides of the pet door frame to create a water tight barrier. Apply the caulk around the perimeter of your door frame and smooth out with your finger for nice finished look.

Important Note: Install Kits are NON-Refundable!